Engineering August 12, 2025

Distortion Control in Multi-Pass Welding: Four Variables That Matter

Distortion in multi-pass thick-section welding is predictable and controllable — if the four key variables are addressed at the engineering stage, not the rework stage.

Distortion Control in Multi-Pass Welding: Four Variables That Matter — illustration

This article is being prepared. The full text will be published shortly.

In the meantime, if you have specific questions about engineering in robotic welding, the technical assessment is the fastest route to a direct engineering answer for your application.

Request Technical Assessment →

← All Insights Request Technical Assessment

More Insights

November 1, 2025

Why Thick-Section Welding Systems Fail After Installation

Most robotic welding system failures in heavy fabrication are not robot failures. They are engineering failures — in distortion management, fixture design, or process sequencing.

October 10, 2025

UT and RT Acceptance in Robotic Welding: Engineering It In From the Start

Inspection acceptance criteria are not a quality check applied after welding. They are an engineering constraint that must shape the welding process from the first pass.

September 5, 2025

Seam Tracking in Heavy Fabrication: What Works and What Doesn't

Seam tracking in thick-section welding is not a plug-in feature. The sensor type, mounting geometry, and process parameters must be matched to the weld joint and material conditions.